1686-20
Knurled Parallel Jaw Grip 4-3/8-Inch Length
- Longer jaws achieve a firm hold, reducing possibility of slippage and damage to cable
- Design includes a latch, plus a large-diameter eye that accommodates large hooks on hoists, winches and tackle blocks
- When latch is closed, it helps maintain cable position in grip jaws
- Same as Cat. No. 1686-10, but with knurled jaws
- Made in USA
Videos
Images
High-Res JPG
1671-10_photo.jpg
Longer knurled jaws achieve a firm hold, reducing possibility of slippage and damage to cable. Design includes a latch, plus a large-diameter eye that accommodates large hooks on hoists, winches and tackle blocks. When latch is closed, it helps maintain cable position in grip jaws.
Specifications
Type:
Parallel Jaw Grip
Application:
Wire Pulling
Special Features:
Longer Jaw and Large Diameter Eye
Overall Length (Inch):
7.2
Overall Length (cm):
18.3
Material:
Steel
Cable Type:
Aircraft, Messenger, Guy Strand
Cable Diameter:
0.2'' to 0.4'' (5.08 to 10.16 mm)
Hot Latch:
No
Swing Latch:
No
Spring:
No
Locking Handle:
No
Jaw Type:
Double V
Teeth Type:
Coarse
Jaw Length (Inch):
4.375
Jaw Length (cm):
11.1
Maximum Safe Load (lb):
10000
Maximum Safe Load (kg):
4535.9
Weight (lb):
4.6
Weight (kg):
2.1
UPC:
092644471810
Additional Information
Warnings
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- When used on/near energized lines, ground, insulate, or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Grips are to be used for temporary installation, not for permanent anchorage.
