1685-20
Parallel Jaw Grip 2-1/2-Inch Length
- Lightweight, compact grips pull an exceptionally wide range of cable sizes and types
- Designed with a round inside-jaw contour for maximum contact to minimize conductor damage and lower serrated jaw to firmly grip insulated cables and conductors
- Design includes a latch that prevents the grip from falling in case of jaw disengagement from the cable
- Large-diameter eye accommodates large hooks on hoists, winches and tackle blocks
- Made in USA
Lightweight, compact grips pull an exceptionally wide range of cable sizes and types. Designed with a round inside-jaw contour for maximum contact to minimize conductor damage. Lower jaw is serrated to firmly grip insulated cables and conductors. Design includes a latch that prevents the grip from falling in case of jaw disengagement from the cable.
Specifications
Type:
Parallel Jaw Grip
Application:
Wire Pulling
Special Features:
Spring
Overall Length (Inch):
9.52
Overall Length (cm):
24.2
Overall Height (Inch):
5.31
Overall Height (cm):
13.5
Overall Width (Inch):
1.22
Overall Width (cm):
3.1
Material:
Steel
Cable Type:
Messenger, EHS, Coated
Cable Diameter:
0.157'' to 0.875'' (3.98 to 22.22 mm)
Hot Latch:
No
Swing Latch:
No
Spring:
Yes
Locking Handle:
No
Jaw Type:
Round
Teeth Type:
Coarse
Jaw Length (Inch):
2.5
Jaw Length (cm):
6.4
Maximum Safe Load (lb):
4500
Maximum Safe Load (kg):
2041.2
Weight (lb):
2.6
Weight (kg):
1.2
UPC:
092644471759
Additional Information
Warnings
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- When used on/near energized lines, ground, insulate, or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Grips are to be used for temporary installation, not for permanent anchorage.
