Parallel Jaw Grip, 0.7 to 1.3-Inch HDPE Wire

1716-60

  • Securely pulls HDPE-coated cable commonly known as tree wire
  • Innovative high-traction surface grips the cable without damaging the outer jacket; pulls cable diameters 0.7 to 1.3-Inch (1.8 to 3.3 cm)
  • Tough carbide grit technology withstands even the harshest jobsite conditions
  • Spring-loaded for one-handed operation and easy placement on the conductor
  • Made in USA
  • Common tree wire cable types include General Cable, Hendrix® aerial systems, Rite Lite BLL conductor and Southwire S2 covered cable
  • Hendrix® is a registered trademark of Marmon Utility, LLC
  • Southwire® is a registered trademark of Southwire Company, LLC
Videos
Images
High-Res JPG 1716-60_photo.jpg
Interactive Catalog

This Parallel Jaw grip was specifically designed to securely pull slippery HDPE-coated cable or tree wire. The innovative high-traction surface grips the cable without damaging the outer jacket. The tough carbide grit technology withstands even the harshest jobsite conditions. The grip is spring-loaded for one-handed operation and easy placement on the conductor.

Specifications
Type:
Parallel Jaw Grip
Cable Type:
HDPE-Coated
Cable Diameter:
0.7'' to 1.3'' (17.78 to 33.02 mm)
Hot Latch:
N
Swing Latch:
N
Spring:
Y
Locking Handle:
N
Jaw Type:
Round
Jaw Length:
5.125'' (13 cm)
Maximum Safe Load:
12,000 lb (5443 kg)
Weight:
8.1 lb (3.7 kg)
UPC:
092644471698
Additional Information
Warnings
  • Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
  • When used on/near energized lines, ground, insulate, or isolate grip before pulling.
  • Do not exceed rated capacity.
  • Always match proper size and type of grip to application.