Interchangeable Jaw Grip Body


This product is no longer in production
  • Constructed of high strength alloy steel, hot forged, heat treated, and galvanized for toughness, strength, and corrosion resistance
  • Suitable for OPGW
  • Offers a full range of interchangeable liners to be inserted between the upper and lower jaws of the grip
  • Cable diameter range: .236'' (6 mm) to .906'' (23 mm)
  • Maximum working load: 6750 lbs. (3062 kg)
High-Res JPG 1628-80_photo.jpg

Save time and effort on the job site with the Klein Tools 1628-70 Interchangeable Jaw Grip. This single grip body works with 12 interchangeable liners, so all you have to do is swap out the liners to work with a different size cable instead of reaching for an entirely new grip. This Interchangeable Jaw Grip is designed for use with optical ground wire (OPGW) conductors.

Cable Diameter:
0.236'' to 0.906'' (5.99 to 23.01 mm)
Maximum Safe Load:
6750 lb (3062 kg)
15.0 lb (6.8 kg)
Additional Information
  • Grips are to be used for temporary installation, not for permanent anchorage
  • When used on/or near energized lines, ground, insulate, or isolate grip before pulling
  • Do not exceed capacity
  • Always match proper size and type of grip to application
  • Before each use, clean jaw area and inspect grip for proper operation to avoid slippage