Klein Tools - For Professionals Since 1857

Chicago® Grip - Dual Conductor Trans

1628-40VR

  • Designed specifically for VR2® (vibration-resistant) and TransPowr® T-2® dual conductor twisted pair cables.
  • Machined upper and lower jaws eliminate scoring or damage to second conductor by contouring to second conductor.
  • Round jaws shaped to provide maximum contact with circumference of cable and prevent cable deformation.
  • Supplied with spring and locking loop handles, allows jaws to be held in open position for easier placement on cable.
  • Grips maintain temporary tension until the wire or cable can be permanently terminated.
  • Orders must specify exact outside diameter of cables, circular mills with strand combination, or manufacturer's code.
  • VR2 is a registered trademark of Southwire Company.
  • TransPowr and T-2 are registered trademarks of General Cable Technologies Corporation.
Images
JPG (High Resolution) 1628-40vru_photo.jpg

Specifications
Cable Diameter:
1192.5 MCM ACSR and AAC Diameter: 1.258'' (31.95)
UPC:
092644470509
Additional Information
Warnings
  • Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
  • Always match proper size and type of grip to application.
  • Do not exceed rated capacity.
  • When used on/near energized lines, ground, insulate, or isolate grip before pulling.
  • Grips are to be used for temporary installation, not for permanent anchorage.