CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

Revision Date: 2/25/99

MANUFACTURER/SUPPLIER'S/NAME:

Aerosol Systems, 9150 Valley View Road, Macedonia, OH 44056 (330) 467-4195

PRODUCT COMPOSITION/ ACGIH TLV OSHA PEL

CAS REG NO. WGT. % TWA STEL TWA STEL UNITS

Propane-Isobutane-n-Butane

74-98-6 20-30 1000 Asphyxiant 1000 Asphyxiant ppm

Acetone

67-64-1 20-30 750 1000 1000 NE ppm

Zinc Compounds

7440-66-6 20-30 NE NE NE NE NA

Toluene

108-88-3 10-20 50 skin NA 200 NA ppm

Xylene

1330-20-7 1-10 100 150 100 NE ppm

Aliphatic Petroleum Distillates

8052-41-3 1-10 100 200 100 NE ppm

Additional Component Information:

Acceptable ceiling concentration for toluene - - 300 ppm; max peak above ceiling - - 8 hr shift - - 500 ppm. Technical grade xylene contains 18-20% ethyl benzene (100-41-4) which has 100 ppm PEL, 100 ppm TLV, 125 ppm STEL, and is subject to the reporting requirements of Section 313 of SARA Title III.

HEALTH HAZARD DATA (ACUTE AND CHRONIC)

May cause dizziness or narcosis in high vapor concentrations. Will cause defatting of skin. Effects are reversible. Long term exposure (years) to high concentrations of vapor may cause lung, liver or kidney damage. The solvents listed have been reported to affect the central nervous system. Aspiration hazard if swallowed. Eye and skin irritant. May irritate respiratory tract. Deliberately concentrating and inhaling the vapor of the contents may be harmful or fatal.

OTHER:

Eye irritation may be severe. May cause cardiac abnormalities. Overexposure to toluene may cause nasal and brain damage.

CARCINOGENICITY:

NA

FIRST AID

Give oxygen. Do not induce vomiting. Wash eyes and skin with water for 15 minutes. Get medical help. Never administer adrenalin following overexposure.

ROUTES OF ENTRY

Ingestion, Inhalation, Skin

SIGNS AND SYMPTOMS OF OVEREXPOSURE_

Inhalation - Difficulty in breathing. Skin - redness. Ingestion - vomiting.

MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE:_

Heart Disease, Respiratory Disorders

Boiling Point -40F to 383F

Vapor Pressure at 70F 70

VAPOR DENSITY (AIR=1) 4.0

EVAP. RATE(BUTYL ACETATE=1) <1

SPECIFIC GRAVITY (WATER=1) The ratio of the weight of a volume of material to the weight of an equal volume of water. Usually expressed as greater than one (>1). 1.0

Solubility Nil

Appearance Grey

Odor Solvent

PH: Not Applicable

STABILITY: STABLE

INCOMPATIBILITY:- Strong oxidizers, strong alkalies acids

HAZARDOUS THERMAL DECOMPOSITION/COMBUSTION PRODUCTS:- Carbon dioxide.

HAZARDOUS POLYMERIZATION: WILL NOT OCCUR

CALIFORNIA PROPOSITION 65:

WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm.

Ozone Depleting Substances:

None

HMIS:

FLAMMABILITY 4 , REACTIVITY 0 , HEALTH 2

NFPA:

FLAMMABILITY 4 , REACTIVITY 0 , HEALTH 2

SARA 313 TITLE III - TOXIC CHEMICALS LIST:

Toluene (CAS 108-88-3) Xylene (CAS 1330-20-7) Zinc Compounds

DOT Shipping Name:

Consumer Commodity, ORM-D

Respiratory Protection Equipment

Use NIOSH approved respirator if TLV limit is exceeded.

VENTILATION:

Local exhaust - yes

PROTECTIVE GLOVES:

None required if spraying.

EYE AND FACE PROTECTION:

Safety glasses.

OTHER PROTECTIVE EQUIPMENT:

Long Sleeves and Long pants

SAFE HANDLING

Do not smoke while using. Wash hands after use.

Flash Point -142F TCC

LOWER EXPLOSION LIMIT : 1.8

UPPER EXPLOSION LIMIT : 9.5

EXTINGUISHING MEDIA:- Water fog, carbon dioxide, foam, dry chemical

UNUSUAL FIRE AND EXPLOSION HAZARDS:- Heated cans may burst.

SPECIAL FIRE FIGHTING PROCEDURES Keep containers cool. Use equipment or shielding required to protect against bursting or venting containers.

SPILL PROCEDURES:_ Use absorbent sweeping compound to soak up material. Put into container. Dispose as hazardous waste.

WASTE DISPOSAL METHODS:_ Dispose as hazardous waste in accordance with EPA RCRA.

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: This section contains precautions for general handling and storage of this particular material. This section is generally for SPBD customers; although the statements should generally apply for internal use as well. Any in-plant rules or procedures should take priority over these handling and storage precautions. Keep away from heat, sparks, or open flame. Store at temperatures below 120F.

OTHER INFORMATION: When spraying more than one half can continuously or more than one can consecutively, use NIOSH approved respirator.

NFPA 30B Level:

3