Back to Data Sheets

CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

Klein Catalog # 51135

BP722 LO\LV RTV Clear

Revision Date: 8/6/98

MANUFACTURER/SUPPLIER'S/NAME:

Aerosol Systems, 9150 Valley View Road, Macedonia, OH 44056 (330) 467-4195

COMPOSITION/INFORMATION ON INGREDIENTS

PRODUCT COMPOSITION/ ACGIH TLV OSHA PEL

CAS REG NO. WGT. % TWA STEL TWA STEL UNITS

Methyltrimethoxysilane

1185-55-3 1-5 200 200 ppm

Aminoethylaminopropyltrimethoxysilane

1760-24-3 1-5 NE

Dimethylpolysiloxane

63148-62-9 10-30 NE

Methoxypolydimethylsiloxane

68037-58-1 60-80 NE

Silanol\STPD Siloxane w\ME Silsqxns

68554-67-6 5-10 NE

Tetramer Treated Fumed Silica

68583-49-3 10-30 10 15 mg/m3

Hexamethyldisilazane

999-97-3 1-5 25 35 ppm

Additional Component Information:

Outer compartment contains a flammable hydrocarbon propellant (Propane/Isobutane/n-Butane blend).

HAZARDS IDENTIFICATION

HEALTH HAZARD DATA (ACUTE AND CHRONIC)

May cause dizziness or narcosis in high vapor concentrations. Will cause defatting of skin. Effects are reversible. Long term exposure (years) to high concentrations of vapor may cause lung, liver or kidney damage. The solvents listed have been reported to affect the central nervous system. Aspiration hazard if swallowed. Eye and skin irritant. May irritate respiratory tract. Deliberately concentrating and inhaling the vapor of the contents may be harmful or fatal.

OTHER:

OTHER:

CARCINOGENICITY:

NA

FIRST AID

Give oxygen. Do not induce vomiting. Wash eyes and skin with water for 15 minutes. Get medical help.

ROUTES OF ENTRY

Ingestion, Inhalation, Skin

SIGNS AND SYMPTOMS OF OVEREXPOSURE_

Inhalation - Difficulty in breathing. Skin - redness. Ingestion - vomiting.

MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE:_

Heart Disease, Respiratory Disorders

PHYSICAL AND CHEMICAL PROPERTIES

Boiling Point NA

Vapor Pressure at 70F NA

VAPOR DENSITY (AIR=1) NA

EVAP. RATE(BUTYL ACETATE=1) <1

SPECIFIC GRAVITY (WATER=1) The ratio of the weight of a volume of material to the weight of an equal volume of water. Usually expressed as greater than one (>1). 1.05

Solubility Nil

Appearance Clear

Odor Ammonia

PH: Not Applicable

STABILITY AND REACTIVITY

STABILITY: STABLE

INCOMPATIBILITY:- Strong oxidizers

HAZARDOUS THERMAL DECOMPOSITION/COMBUSTION PRODUCTS:- Carbon dioxide. Ammonia. Methanol. Silicon dioxide. If heated in the presence of air above 150C (300F), product may form formaldehyde vapors.

HAZARDOUS POLYMERIZATION: WILL NOT OCCUR

REGULATORY INFORMATION

CALIFORNIA PROPOSITION 65:

NONE

Ozone Depleting Substances:

None

HMIS:

FLAMMABILITY 0 , REACTIVITY 0 , HEALTH 2

NFPA:

FLAMMABILITY 0 , REACTIVITY 0 , HEALTH 2

SARA 313 TITLE III - TOXIC CHEMICALS LIST:

None

DOT Shipping Name:

Consumer Commodity, ORM-D

CONTROL MEASURES

Respiratory Protection Equipment

Use NIOSH approved respirator if TLV limit is exceeded.

VENTILATION:

Local exhaust - yes

PROTECTIVE GLOVES:

None required if spraying.

EYE AND FACE PROTECTION:

Safety glasses.

OTHER PROTECTIVE EQUIPMENT:

Long Sleeves and Long pants

SAFE HANDLING

Do not smoke while using. Wash hands after use. Remove contact lenses before using sealant. Do not handle lenses until all sealant has been cleaned from the fingertips, nails and cuticles. Residual sealant may remain on fingers for several days and transfer to lenses and cause severe eye irritation.

PRECAUTIONS FOR SAFE HANDLING AND USE

Flash Point None

LOWER EXPLOSION LIMIT : ND

UPPER EXPLOSION LIMIT : ND

EXTINGUISHING MEDIA:- Water fog, carbon dioxide, foam, dry chemical

UNUSUAL FIRE AND EXPLOSION HAZARDS:- Heated cans may burst.

SPECIAL FIRE FIGHTING PROCEDURES Keep containers cool. Use equipment or shielding required to protect against bursting or venting containers.

SPILL PROCEDURES:_ Use absorbent sweeping compound to soak up material. Put into container. Dispose as hazardous waste.

WASTE DISPOSAL METHODS:_ Dispose as hazardous waste in accordance with EPA RCRA.

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: This section contains precautions for general handling and storage of this particular material. This section is generally for SPBD customers; although the statements should generally apply for internal use as well. Any in-plant rules or procedures should take priority over these handling and storage precautions. Keep away from heat, sparks, or open flame. Store at temperatures below 120F.

OTHER INFORMATION: When spraying more than one half can continuously or more than one can consecutively, use NIOSH approved respirator.

NFPA 30B Level:

1

Back to Data Sheets

For questions regarding Klein Tools, please use the Contact Klein Tools page. For questions regarding
Klein Tools' policy regarding the use of this site, please see our Legal Notice/Privacy Statement.