You are here
Electrician's Insulated High-Leverage Diagonal-Cutting Plier - Angled
ACSR, Screws, Nails and Most Hardened Wire
Combination Polished Black-Oxide
6-3/4'' (171 mm)
High Dielectric Plastic
13/16” (21 mm)
7/16” (11 mm)
1-3/16” (30 mm)
Induction Hardened Steel
8-1/4'' (210 mm)
Flame Retardant and Impact Resistant Handle
IEC 60900 and ASTM F1505
Whenever possible, always de-energize lines and equipment prior to working on or around them. Klein insulated tools are designed only to reduce the chance of injury where the tool may make contact with an energized source.
Only use tools that are marked with the official international 1000-volt rating symbol shown below, if there is any chance that the tools will make contact with an energized source.
Always inspect your tools before use.
Always wear approved eye protection.
Do NOT touch uninsulated portion of the tool or any conductive object when either might contact an energized source.
Keep tool clean, dry and free of any surface contaminants.
Destroy tool if the insulation is damaged in any way.