You are here

Chicago® Grip - Dual Conductor Transmission

Cat. No.: 
Product Features
Designed specifically for VR2® (vibration-resistant) and TransPowr® T-2® dual conductor twisted pair cables.
Machined upper and lower jaws eliminate scoring or damage to second conductor by contouring to second conductor.
Round jaws shaped to provide maximum contact with circumference of cable and prevent cable deformation.
Supplied with spring and locking loop handles, allows jaws to be held in open position for easier placement on cable.
Grips maintain temporary tension until the wire or cable can be permanently terminated.
Also for use on aluminum, copper, weatherproof coated wire and PVC covered conductors
Also for use on aluminum, copper, weatherproof coated wire and PVC covered conductors
Available in U size. Made to order sizes also available. Please call for expected delivery dates.
Orders must specify exact outside diameter of cables, circular mills with strand combination, or manufacturer's code.
Each grip is made for one size cable only.
VR2 is a registered trademark of Southwire Company.
TransPowr and T-2 are registered trademarks of General Cable Technologies Corporation.
Klein Tools Feature Icon - klein/round-grip-jaw-icon.jpgKlein Tools Feature Icon - klein/made_in_usa.jpg
Cable Capacity:
1192.5 MCM ACSR and AAC Diameter: 1.258'' (31.95)
Jaw Length:
10-3/4'' (273 mm)
Maximum Safe Load:
25,000 lbs. (11,340 kg.)
Minimum Cable:
1113 MCM ACSR and AAC Diameter: 1.212'' (30.75)
Sub Brand:
Chicago Grip

Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.

Always match proper size and type of grip to application.

Do not exceed rated capacity.

When used on/near energized lines, ground, insulate, or isolate grip before pulling.

Grips are to be used for temporary installation, not for permanent anchorage.

Buy Now